Engineering Quiz Questions with Answers (CSE, ECE,Civil, ME & Others)

Engineering Quiz Questions with Answers (CSE, ECE,Civil, ME & Others)

0

Engineering Quiz

Candidates it you are looking for Engineering Quiz for all branches such as CSE, ECE, Civil, ME & Others then you are at the right place. Here on this page we are providing the Engineering Questions with Answers. By answering these questions, you’ll get a better idea about your strengths, skills and personal qualities.

This Engineering Quiz is categorized into Electronics, Civil, Computer, Mechanical Quiz, and so on. You can participate in this Quiz and analyse your knowledge as well gain knowledge of new things. Candidates in the below section of the page of recruitmentlauncher.com, we are providing some engineering questions and answers, candidates take a look below.

Engineering Quiz

Q1- The centre of gravity of a triangle is at the point where three





Q2- At a given instant ship A is travelling at 6 km/h due east and ship B is travelling at 8 km/h due north. The velocity of B relative to A is





Q3- Biochemical Oxygen Demand (B.O.D.) of safe drinking water must be





Q4- If pH value of water is





Q5- The thickness of a sharp crested weir is kept less than





Q6- A short tube mouthpiece will not run full at its outlet if the head under which the orifice works, is





Q7- Pick up the polymineralic rock from the following:





Q8- The velocity factor of a transmission line depends on





Q9- MICR stands for





Q10- Binary number 1101.101 is equivalent to decimal number?





Q11-   In a three cavity klystron amplifier, the oscillations are excited in





Q12- A cordless telephone using separate frequencies for transmission in base and portable units is known as





Q13- A modem is classified as low speed if data rate handled is





Q14- Which of the following oscillators is suitable for frequencies in the range of mega hertz?





Q15- The function of an AM detector circuit is to





Q16- If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is





Q17- The main object of scientific layout is





Q18-   The flow through a nozzle is regarded as





Q19-   The ratio of total useful heat drop to the total isentropic heat drop, is called





Q20- Screws used for power transmission should have







NO COMMENTS

Leave a Reply